Release time:2023-11-12 15:26:24 Hits: Current position: Home > News
This article mainly introduces:
Costa Rica hydraulic cylinder,shearing machine cylinder manufacturer,shearing machine cylinder(Costa Rica shearing machine cylinder,produced by Hengyu Hydraulic Co., Ltd)
shearing machine cylinder are widely used in Costa Rica,because of no need for deceleration device,long service life,smooth movement.So our company has designed shearing machine cylinder for customers from Costa Rica.
The shearing machine cylinder is not the same as the shearing machine cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the shearing machine cylinder can not be used as a high-power power component, but the shearing machine cylinder can be used as a relatively large power component, or the shearing machine cylinder system can be used.
When purchasing the shearing machine cylinder, try to clarify the following parameters of the shearing machine cylinder: A. shearing machine cylinder diameter, rod diameter, stroke; B. Working pressure or shearing machine cylinder load; C. Working environment temperature; D. Working medium; E. Operating speed; F. Other parameters, such as connection form, mounting size, etc. In this way, the right shearing machine cylinder type can be found accurately and quickly.
In use, the shearing machine cylinder should try to avoid the friction iron powder or iron filings formed by buffering the plunger. When the matching gap of the buffer device is small and the transverse load on the piston rod is large, the sintering phenomenon may be caused. These friction iron powder or the metal fragments that have fallen off as a result of sintering will remain in the shearing machine cylinder.
The daily inspection of the shearing machine cylinder includes: checking the connection of the shearing machine cylinder and the pipe joint for leaks. Check the shearing machine cylinder rod for leaks. Check the shearing machine cylinder connection for leaks. When the shearing machine cylinder moves, the work is normal and smooth. Whether the shearing machine cylinder has internal leakage.
How many tons is the oil cylinder 16mpa?
It depends on the cross-sectional area of the cylinder A(mm2)F=16mpa×A unit is (tons).
PLC+ inverter + motor + pump + solenoid valve + cylinder combination, can control the accuracy of cylinder position?
In the case of extremely high accuracy requirements, you can not, please consider a few problems: 1, hydraulic oil can be compressed, it is elastic like a spring. Therefore, in the general hydraulic servo system, the valve control is far more accurate than the pump control. Because the valve can be installed very close to the hydraulic cylinder, or even installed on the hydraulic cylinder, but the pump must go through the tubing and then into the hydraulic cylinder, there is a long distance, which greatly reduces the rigidity of the system and increases the difficulty of control. 2, the quantitative pump is first of all leaking, and there is 10%-20% flow pulsation. Secondly, and more unfortunately, the leakage of the pump is related to the pressure and is non-linear.