Release time:2023-11-12 15:25:58 Hits: Current position: Home > News
This article mainly introduces:
Slovenia hydraulic cylinder,tailboard balance cylinder manufacturer,tailboard balance cylinder(Slovenia tailboard balance cylinder,produced by Hengyu Hydraulic Cylinder Factory)
tailboard balance cylinder are widely used in Slovenia,because of no need for deceleration device,long service life,smooth movement.So our company has designed tailboard balance cylinder for customers from Slovenia.
tailboard balance cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the tailboard balance cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the tailboard balance cylinder. c. The tailboard balance cylinder seal is extruded, if the O-ring is obviously extruded at the tailboard balance cylinder seal, replace the tailboard balance cylinder seal.
How the cavitation of the tailboard balance cylinder is formed: With the gradual rise of pressure, the gas in the oil will become bubbles, when the pressure rises to a certain limit value, these bubbles will break under the action of high pressure, so that the high temperature and high pressure gas will quickly act on the surface of the parts, resulting in cavitation of the tailboard balance cylinder, resulting in corrosive damage to the parts.
In recent years, the processing process of the tailboard balance cylinder generally adopts the rolling method, which is a pressure finishing processing, which uses the cold plastic characteristics of the metal at room temperature, and uses the rolling tool to exert a certain pressure on the surface of the workpiece, so that the surface metal of the workpiece produces plastic flow, and fills in the low concave trough of the original residue, and the roughness value of the workpiece surface is reduced. Due to the plastic deformation of the rolled surface metal, the surface tissue is cold hardened and the grain is fine, forming a dense fiber, and forming a residual stress layer, and the hardness and strength are increased, thus improving the wear resistance, corrosion resistance and compatibility of the workpiece surface. Rolling is a plastic machining method without cutting.
The difference between the integral tailboard balance cylinder and the split tailboard balance cylinder: The integral tailboard balance cylinder and the split tailboard balance cylinder in the tailboard balance cylinder are two different tailboard balance cylinders, and they are very different. The whole tailboard balance cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split tailboard balance cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and tailboard balance cylinder damage. Therefore, it is obvious that the answer to this question is for difference.
How many tons is the oil cylinder 16mpa?
It depends on the cross-sectional area of the cylinder A(mm2)F=16mpa×A unit is (tons).
What valve is used to control the speed of the cylinder?
Hydraulic cylinder for lifting is generally the piston rod downward installation, to achieve the fast and slow speed of the cylinder, you can add a two-digit three-way electromagnetic reversing valve + a throttle valve on a branch at the bottom of the cylinder, you can achieve speed change, control mode can be controlled by time control can also be controlled by stroke switch. If you want to achieve more accurate control can use proportional valve control.