Release time:2023-11-08 15:23:35 Hits: Current position: Home > News
This article mainly introduces:
Uruguay hydraulic cylinder,track steering cylinder manufacturer,track steering cylinder(Uruguay track steering cylinder,produced by Hebei Hengyu company)
track steering cylinder are widely used in Uruguay,because of no transmission clearance,powerful torque,clever hydraulic energy conversion.So our company has designed track steering cylinder for customers from Uruguay.
The meaning of the track steering cylinder model marked by the track steering cylinder manufacturer: for example, 160/100-1150, its meaning: from a professional point of view, 160 refers to the track steering cylinder diameter, which is 160mm, and the 100 behind refers to the rod diameter, which is 100mm. The 1150 refers to the track steering cylinder stroke, which is 1150mm. Therefore, on this point, we should have a correct understanding and can not make mistakes.
The repair method of track steering cylinder wear: 1. Metal repair material is applied to the scratched surface; The first layer should be thin, uniform and fully covered with the scratched surface to ensure the best adhesion between the material and the metal surface, and then apply the material to the entire repair site and press repeatedly to ensure that the material is filled and reaches the required thickness, so that it is slightly higher than the surface of the guide rail; 2, the material at 24℃ to fully achieve the performance of 24 hours, in order to save time, can be through the tungsten halogen lamp to increase the temperature, the temperature rises 11℃, the curing time will be reduced by half, the best curing temperature 70℃; 3. After the material is cured, use a fine grinding stone or a scraper to repair and smooth the material higher than the surface of the guide rail, and the construction is completed.
The quality of the track steering cylinder can not be ignored in the purchase of the track steering cylinder. The track steering cylinder is the main component of the track steering cylinder, the single pillar for mining, the hydraulic support, the gun tube and other products, and its processing quality directly affects the life and reliability of the entire product. track steering cylinder processing requirements are high, its internal surface roughness requirements are Ra0.4 ~ 0.8μm, the coaxiality, wear resistance requirements are strict. The basic feature of track steering cylinder is deep hole processing, which has always troubled the processing personnel.
In use, the track steering cylinder should try to avoid the friction iron powder or iron filings formed by buffering the plunger. When the matching gap of the buffer device is small and the transverse load on the piston rod is large, the sintering phenomenon may be caused. These friction iron powder or the metal fragments that have fallen off as a result of sintering will remain in the track steering cylinder.
Is there a national standard for the testing of hydraulic cylinders?
Generally speaking, the cylinder test is carried out according to JB/JQ20302 Allowable leakage of cylinder in pre-factory leakage test. GB2879 hydraulic cylinder piston and piston rod dynamic seal groove type, size and tolerance. GB6578 hydraulic cylinder piston rod dust ring groove type, size and tolerance. GB7938 hydraulic cylinder and cylinder nominal pressure series, etc.
How big is the motor and oil pump for the 80 cylinder?
Pump motor selection is not only related to cylinder diameter but also speed system, it is recommended to provide system diagram and speed requirements, generally speaking, most of the 80 cylinder on the market is equipped with 3-4KW motor, 10-20 oil pump.