Release time:2023-11-26 09:49:35 Hits: Current position: Home > News
This article mainly introduces:
Austria hydraulic cylinder,shearing machine cylinder manufacturer,shearing machine cylinder(Austria shearing machine cylinder,produced by Hengyu Group)
shearing machine cylinder are widely used in Austria,because of simple structure and reliable operation,excellent temperature resistance,no transmission clearance.So our company has designed shearing machine cylinder for customers from Austria.
shearing machine cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the shearing machine cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the shearing machine cylinder. c. The shearing machine cylinder seal is extruded, if the O-ring is obviously extruded at the shearing machine cylinder seal, replace the shearing machine cylinder seal.
The material, shape and compression of the shearing machine cylinder seal have a great impact on the service life and work efficiency of the shearing machine cylinder. In addition to requiring a reliable seal, it should also have a long service life and less friction loss. At present, there are many seal manufacturers in the country, and it is also crucial to choose high-quality seals with reliable and stable quality.
The piston rod of the shearing machine cylinder has two kinds of solid rod and hollow rod, and one end of the hollow piston rod needs to be set aside for welding and heat treatment. The solid piston rod material is 35, 45 steel, and the hollow piston rod material is 35, 45 seamless steel pipe. After rough machining, the piston rod is conditioned to 229~285HB in India, and if necessary, the hardness is 45~55HRC after high-frequency quenching.
If the seal of the shearing machine cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.
Why do two hydraulic cylinders lift out of sync?
There may be several situations (do not know the result of the equipment, may not be accurate) 1, whether the slow one is worn 2, whether there is air in the slow cylinder 3, if the two cylinders are supplied by the same oil port, whether the slow joint is blocked (some processing residue will reach a certain oil port under a certain coincidence condition, This situation will not happen if it is not necessarily good before) 4, the oil seal in the slow cylinder leaks, causing the feed oil to leak from the return oil end. Point 4 is most likely because it is invisible and a technical failure. If it is a dual oil feed (separate oil feed), it is also necessary to check the oil supply system and the oil return system (valve type).
What steel pipe does hydraulic cylinder use? This problem is very general. Carbon steel pipe or ordinary seamless steel pipe are all ok, but then there are rolling, quilting, heat treatment and other steps, and the requirements are different, the wall thickness is different, the material is different. It depends on the circumstances.