Release time:2023-11-24 16:13:32 Hits: Current position: Home > News
This article mainly introduces:
Panama hydraulic cylinder,single rack cylinder manufacturer,single rack cylinder(Panama single rack cylinder,produced by Hengyu Hydraulic Co., Ltd)
single rack cylinder are widely used in Panama,because of high work efficiency,excellent fatigue and impact resistance,simple structure and reliable operation.So our company has designed single rack cylinder for customers from Panama.
The internal leakage of the single rack cylinder should be prevented when the single rack cylinder is used. The internal leakage of single rack cylinder includes the leakage caused by excessive wear of single rack cylinder block seal, piston rod and seal cover seal and piston seal. The cause of sealing leakage between the piston rod and the seal cover is that the seal is wrinkled, squeezed, torn, worn, aging, deterioration, deformation, etc., and a new seal should be replaced at this time.
The definition of the minimum starting pressure of the single rack cylinder refers to the minimum working pressure of the single rack cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the single rack cylinder parts and the size of the sealing friction.
The repair method of the single rack cylinder: the repair of the single rack cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.
single rack cylinder can not drive the load troubleshooting: oil pressure is too low. single rack cylinder selection specifications are too small. Leakage in single rack cylinder or associated hydraulic system element.
When the superimposed hydraulic control valve is added to the bottom of a solenoid valve and a double directional throttle valve, why does the cylinder shock on the return trip?
The stack hydraulic control check valve must be added above the stack one-way throttle valve.
Do the collecting cylinder, distributing cylinder and distributing cylinder on the organic heat carrier boiler need to be notified separately as the pressure vessel for construction?
Do not need to be installed as a separate pressure vessel to inform, according to the organic heat carrier boiler can be informed. Write a "special equipment installation, renovation and maintenance notice" issued on it.