Release time:2023-11-24 08:39:19 Hits: Current position: Home > News
This article mainly introduces:
Kazakhstan hydraulic cylinder,folding machine cylinder manufacturer,folding machine cylinder(Kazakhstan folding machine cylinder,produced by Hengyu Hydraulic Cylinder Factory)
folding machine cylinder are widely used in Kazakhstan,because of no need for deceleration device,long service life,smooth movement.So our company has designed folding machine cylinder for customers from Kazakhstan.
folding machine cylinder use should try to avoid sealing belt into the folding machine cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the folding machine cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the folding machine cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.
Disassembly folding machine cylinder: When disassembly folding machine cylinder, strictly prevent damage to the screw thread at the top of the piston rod, the screw thread of the folding machine cylinder head and the surface of the piston rod. It should also be noted that the piston cannot be played out from the folding machine cylinder.
In the case of serious wear on the inner surface of the folding machine cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the folding machine cylinder manufacturing process for replacement. The folding machine cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.
folding machine cylinder spool stuck or valve hole blocked How to solve: When the flow valve or direction valve spool stuck or valve hole blocked, the folding machine cylinder prone to misoperation or action failure. At this time, the contamination of the oil should be checked; Check whether dirt or colloidal deposits are stuck in the spool or blocking the valve hole; Check the wear of the valve body, clean and replace the system filter, clean the fuel tank, and replace the hydraulic medium.
What is the cause of the sound of the excavator arm cylinder?
Hydraulic excavator cylinder includes boom cylinder, bucket rod cylinder and bucket cylinder, four cylinders. The sound of boom cylinder may be the wear of hydraulic cylinder block bushing, piston rod bushing and shaft pin. The main reason: poor lubrication, followed by improper clearance in the assembly process. Countermeasures: (1) Strictly lubricate each shaft pin at least once every 8 hours when the excavator is initially used for 100 hours and under harsh conditions; In other working conditions, lubricate each pin at least once every 50 hours. (2) If the lubricating oil passage is found to be blocked, it must be stopped for rectification. (3) Require assembly, replacement of all parts of the shaft pin, bushing strictly comply with the assembly testing standards and operating procedures.
How to exhaust hydraulic cylinder?
Exhaust: The hydraulic system generally does not have exhaust, the use of the tank can exhaust, the oil operation will bring the gas back to the tank, and the tank can be communicated with the atmosphere. The gas will escape from the oil.