Release time:2023-11-20 09:49:14 Hits: Current position: Home > News
This article mainly introduces:
Libya hydraulic cylinder,steering cylinder manufacturer,steering cylinder(Libya steering cylinder,produced by Hengyu Hydraulic Cylinder Factory)
steering cylinder are widely used in Libya,because of high work efficiency,excellent fatigue and impact resistance,no need for deceleration device.So our company has designed steering cylinder for customers from Libya.
There are some honeycomb holes in the inner wall of the steering cylinder, piston or piston rod surface. How is this formed? When we repair the steering cylinder, we can see that there are some honeycomb holes on the inner wall of the steering cylinder, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the steering cylinder is targeted to prevent. Is very necessary.
The steering cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the steering cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the steering cylinder wall due to the stiffness and the weight of the parts, causing scars.
steering cylinders in series, parallel and series parallel. Series: In the steering cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Series: In the steering cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Parallel: the pressure oil in the steering cylinder is connected with the inlet oil of each reversing valve, and the return oil is collected by the return oil circuit. Series parallel: For this one, compared with the simple series and parallel, it is slightly more complicated, but it is not impossible to understand. The series refers to the oil in the steering cylinder, which is in series form, but can not form a series circuit, and the parallel refers to the oil return circuit of each valve, which is in parallel.
After the steering cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.
How does the cylinder work?
Hydraulic transmission principle: oil as the working medium, through the change of the sealing volume to transfer movement, through the internal pressure of the oil to transfer power. 1. The power part - converts the mechanical energy of the prime mover into the pressure energy of the oil (hydraulic energy). For example: hydraulic pump. 2, the executive part - the hydraulic pump input oil pressure energy into the mechanical energy to drive the working mechanism. For example: hydraulic cylinder, hydraulic motor. 3, the control part - used to control and adjust the oil pressure, flow and flow direction. For example: pressure control valve, flow control valve and direction control valve. 4, the auxiliary part - the first three parts are connected together to form a system, which plays the role of oil storage, filtration, measurement and sealing.
What is the relationship between medium cylinder and side cylinder ratio of forklift truck?
The middle cylinder and the side cylinder seem to have no relationship, as long as the lifting speed required by the design can be ensured, but the diameter of the cylinder can not be too thin, so as to avoid the middle cylinder acting first when the high gantry vibration lifting, and then the two cylinders acting again.